• This equipment is intended to be grounded. Ensure that the host is connected to earth ground during
normal use.
• Do not remove the outer shell of the Sensor. Doing so will invalidate your warranty.
• Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Blank
faceplates and cover panels prevent exposure to hazardous voltages and currents inside the chassis, contain
electromagnetic interference (EMI) that might disrupt other equipment, and direct the ow of cooling air
through the chassis.
• To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage
(TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN
ports both use RJ-45 connectors. Use caution when connecting cables.
• This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
• Operation of this equipment in a residential area is likely to cause harmful interference in which case users
will be required to correct the interference at their own expense.
Contents of the Sensor box
The following accessories are shipped in the Sensor box:
• One Sensor.
• One power cord. McAfee provides a standard, 2m NEMA 5-15P (US) power cable (3 wire). International
customers are provided a country-appropriate power cable with specic V/A ratings.
• One set of rack mounting ears.
• One printed Quick Start Guide.
• Release Notes.
Unpack the Sensor
Task
1
Place the Sensor box as close to the installation site as possible.
2
Position the box with the text upright.
3
Open the top aps of the box.
4
Remove the accessory box within the Sensor box.
5
Verify you have received all parts.
These parts are listed on the packing list and in Contents of the Sensor box.
6
Remove the Slide Rail Kit.
7
Pull out the packing material surrounding the Sensor.
2
Before you install
Contents of the Sensor box
12
McAfee
®
Network Security Platform M-1250/M-1450 Sensor Product Guide
To Next Page
Loading...
