McAfee NS9100 - User Manual

NS9x00 Quick Start Guide
Revision E
McAfee
®
Network Security Platform
This quick start guide explains how to quickly set up and activate your McAfee
®
Network Security Platform
NS-series Sensor in in-line mode.
All product documentation referenced in this quick start guide is found on the McAfee Service Portal.
The NS9100/NS9200 Sensor model
Figure 1 Sensor front panel
1
Console port (1)
2
QSFP+ 40 Gigabit Ethernet ports (2)
3
Two slots for I/O modules (Any combination of the interface modules can be used)
• QSFP+ 40 Gigabit Ethernet ports (4)
• QSFP+ 40 Gigabit Ethernet ports (2)
1

Summary

Slide Rail Installation - Initial Steps

Remove Inner Member from Slides

Instructions for detaching the inner member of the slide rails from the outer member.

Slide Rail Installation - Rack and Chassis

Install Slides to Rack

Steps to install the slide rails onto the server rack.

Install Inner Member to Chassis

Install Manager Software

Add Sensor to Manager

Add New Device Configuration

Details on entering device name, type, and shared secret to add a Sensor.

Configure Sensor Information

Set Sensor Name and Network Details

Commands to set the Sensor name, gateway, manager IP, and Sensor IP address.

Set Shared Secret Key

Procedure for setting the shared secret key for secure Sensor-Manager communication.

Verify Successful Installation

Check Sensor Status and Manager View

Verifying Sensor status via CLI and Manager interface for operational readiness.

Configure Port Settings

McAfee NS9100 Specifications

General

Brand	McAfee
Model	NS9100
Category	Firewall
Language	English