McCrometer ProComm - Appendix A - Capability Checklist; Appendix B - Default Configuration

30125-48 Rev. 1.0 | 05AUG2021
Page 12
APPENDIX A - CAPABILITY CHECKLIST
APPENDIX A - CAPABILITY CHECKLIST
Device Type Transmitter
HART Revision 7.0
Device Description available Yes
Number and Type of Sensors 1
Number and Type of Actuators None
Number and Type of Host Side Signals 1: 4 - 20mA Analog
Number of Device Variables 8
Number of Dynamic Variables 4
Mappable Dynamic Variables? No
Number of Common-Practice Commands 14
Number of Device-Specic Commands 9
Bits of Additional Device Status 8
Alternative Operating Modes? No
Burst mode? No
Write-protection? Yes
APPENDIX B - DEFAULT CONFIGURATION
Parameter Default Value
Lower Range Value 0 - Depends on conguration
Upper Range Value 0 - Depends on conguration
PV Units l/sec
Sensor Type Check the coupled sensor
Number of Wires 3
Damping Time Constant 1 second
Fault-Indication Jumper Not Used
Write-Protect Jumper Not Used
Number of Response Preambles 5 to 20