McCrometer ProComm - Default Chapter; Table of Contents

SAFETY............................................ 1
1.0 Introduction ................................. 2
1.1 Scope ......................................2
1.2 Purpose ....................................2
1.3 Who should use this document? .............2
1.4 Abbreviations and denitions ............... 2
1.5 References ................................. 2
1.6 Device Identication........................ 2
2.0 Product Overview ............................ 2
3.0 Product Interfaces ........................... 3
3.1 Host interface ..............................3
3.2 Local Interfaces, Jumpers and Switches....... 3
4.0 Device Variables ............................. 4
5.0 Dynamic Variables ........................... 4
6.0 Status Information ........................... 5
6.1 Device Status ............................... 5
6.2 Extended Device Status .....................5
6.3 Additional Device Status (Command #48).....5
7.0 Universal Commands......................... 5
8.0 Common-Practice Commands................. 6
8.1 Supported Commands ......................6
8.2 Burst Mode ................................. 6
8.3 Catch Device Variable .......................6
9.0 Device-Specic Commands ................... 7
10.0 Tables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
10.1 Write Protect ...............................9
10.2 Totalizers...................................9
10.3 Flow Direction .............................10
11.0 Performance................................10
11.1 Sampling Rates ............................10
11.2 Power-Up .................................10
11.3 Reset......................................10
11.4 Self-Test ...................................10
11.5 Command Response Times .................11
11.6 Busy and Delayed-Response ................11
11.7 Long Messages ............................11
11.8 Non-Volatile Memory ......................11
11.9 Modes.....................................11
11.10 Write Protection ...........................11
11.11 Damping ..................................11
APPENDIX A - CAPABILITY CHECKLIST ..............12
APPENDIX B - DEFAULT CONFIGURATION ...........12
Table of Contents
30125-48 Rev. 1.0 | 05AUG2021
Page ii