10
|
ENGLISH
STEAM CLEANING ACCESSORIES
WARNING: Do not connect accessories while unit is emitting steam.
JET NOZZLE / SCRAPER / SQUEEGEE / TRIANGLE BRUSH
1. Select one of the three accessories (Jet Nozzle shown as example) and push onto the Steam
Nozzle (A).
2. Rotate accessory until the yellow lock/release button snaps into the accessory hole (B).
NOTE: The Jet Nozzle, Scraper, Squeegee and Triangle Brush can be connected to the
end of an Extension Wand for reaching high or difcult spots. Connect the Extension
Wand (or Wands) as outlined on Page 8, then connect your desired accessory to the
Wand in the same way as you would normally connect to the Steam Nozzle.
UTILITY BRUSHES / ANGLED NOZZLE / SCRUB PAD
NOTE: Accessories connect to the Jet Nozzle, not the Steam Nozzle.
1. Firmly press accessory onto tip of Jet Nozzle. Press it on as far as possible to prevent steam
leakage (See gure 3).
2. To remove accessory, simply grip it rmly and pull it off Jet Nozzle.
Assembling Your Deluxe Canister
Steam System
FIGURE 3
Steam Nozzle
B
A
To Next Page
Loading...
Need help?
General
