McCulloch MC1385 - Microfiber Pad Attachment

ENGLISH
|
9
MICROFIBER PADS
1. Lay one Microber Pad on at surface, with two fastener strips facing upward.
2. Align Mop Head with Microber Pad. Make sure Mop Head is oriented with Pad as shown,
and centered as best as possible (See gure 2-A).
3. Press Mop Head rmly down onto Microber Pad. Fastener strips will adhere to Pad Grips on
underside of Mop Head. Pad should now be attached and ready for use (See gure 2-B).
CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.
NOTE: Microber Pads are machine washable. To avoid picking up lint, washing sepa-
rately from other fabrics is recommended. Only use liquid detergent. Avoid using any
fabric softeners or bleach. Air drying is recommended; machine drying on a low heat
or air dry setting is acceptable as well.
The Mop Head and Microber Pads are perfect for use on these hard oor surfaces:
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces. Sur-
faces that are not properly sealed may be warped or damaged by exposure to heat and
moisture.
Care should also be taken when steaming sealed hardwood oors, as prolonged ex-
posure to steam in a single spot may cause damage and discoloration. To avoid this,
keep the Mop Head in constant motion on these surfaces.
Steam may remove the sheen from some oors that have been treated with wax.
Extremely rough textured oors may tear or damage Microber Pads.
Before steaming any ooring, it is recommended to consult the manufacturer’s guide-
lines. For ooring in question, always test on a small inconspicuous area before pro-
ceeding.
A B
FIGURE 2
•
Sealed Laminate
•
Linoleum
•
Glazed Ceramic
•
Granite
•
Sealed Hardwood
•
Stained Concrete
•
Marble
•
Vinyl
•
Tile
Assembling Your Deluxe Canister
Steam System