McCulloch MC1385 User Manual

ENGLISH
|
17
Troubleshooting
Unit fails to heat up.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Unit is not plugged in.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Unit is damaged or otherwise in
need of repair.
Water level in Boiler is running
low.
Boiler is empty.
Water condensation in Steam
Hose.
Boiler has been
overlled.
Plug power cord into electrical outlet.
Refer to Mineral Build-up section
on Page 16 for cleaning procedure.
Refer to Mineral Build-up section
on Page 16 for cleaning procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 19 for details).
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to Filling Boiler procedure
on Page 13.
Refer to Filling Boiler procedure
on Page 13.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Trigger. Continue until
excess water is released.
Filling the Boiler with more
than 64 oz. (1,892 ml.) of water
interferes with steam production,
resulting in water condensation
in steam.
Always ll unit with correct amount
of water. (see Page 13 for details)
PROBLEM POSSIBLE CAUSE SOLUTION
Accessories do not stay rmly
connected to Steam Nozzle.
Accessories not properly installed. Check to make sure that acces-
sories are properly connected, per
procedures on Pages 8-11.
Floor surfaces appear cloudy or
streaky after steaming.
Microber Pad is dirty.
Hard water residue on oor.
Replace Microber Pad with a
clean one.
Switch to distilled or
de-mineralized water.
Pressure Gauge will not reach 4
bar (58psi).
Variances in environmental tem-
perature and amount of water in
boiler could affect the amount of
pressure your unit will reach.
Unit will provide optimal steam
at 2 bar. Normal pressure with
continuous steam ow is approxi-
mately 2 Bar (29 PSI).

McCulloch MC1385 Specifications

General

Power	1500 W
Power Cord Length	18 feet
Hose Length	10 feet
Weight	13 pounds
Accessories	measuring cup
Steam Temperature	212°F