14
|
ENGLISH
Using Your Deluxe Canister Steam
System
GENERAL OPERATION
NOTE: Be sure that Boiler has been lled and that desired accessories are connected be-
fore following these steps.
1. For rst time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Switch Lighted On/Off Switch to “On” position.
3. Once 2 Bar (29 PSI) is reached, the unit is ready to begin steaming. At approximately 4 Bar
(58 PSI), the unit will have maximum pressure.
NOTE: As steam is released, pressure will drop. This is a normal condition. When steam
ow is stopped, pressure will begin to increase. Normal pressure with continuous steam
ow is approximately 2 Bar (29 PSI).
4. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Trigger. To sanitize surfaces, point Nozzle, press Trigger and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Trigger.
5. Keep Steam Trigger pressed for a continuous ow of steam. You may also hold the Steam Trig-
ger, then push the Steam Trigger Lock to lock it down. This will allow a continuous ow of steam
without need of holding the Steam Trigger down manually. Steam output can be adjusted by
simply turning the Steam Adjustment Knob.
6. Using a back-and-forth motion over the area you are steaming will further enhance the clean-
ing process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wip-
ing the area while it is still wet is recommended, but use caution when wiping surfaces such as metal
that may still be hot.
7. Once steaming tasks are complete, turn the unit “Off” and unplug. Follow steps under Proper
Storage procedure on Page 16 of this manual.
STEAM MOPPING
NOTE: Be sure that Boiler has been lled and that all steam mopping accessories are con-
nected before following these steps.
It is recommended to sweep or vacuum hard oors before mopping.
To Next Page
Loading...
Need help?
General
