6
4 - ASSEMBLY INSTRUCTIONS
4-1. “P” HANDLE ASSEMBLY (MT3075)
1. To install handle onto unit, you will need the following
components from your user kit: “P” handle (A & B),
screws (C) and nuts (D). (Figure 4-1A).
2. Install the handle (B) on the shaft 160-200mm from
throttle and tighten the 2 screws (C) and nuts (D).
4-2. “J” HANDLE ASSEMBLY (MT3090/
MT30775/MT30790)
1. To install handle onto unit, you will need the following
components from your user kit: “J” handle (A), middle
clamp housing (B), upper and lower clamps (C) and
screws (D). (Fig. 4-2A)
2. Install the middle clamp housing (B) on the shaft near
the arrows on the sticker (warning label E ), put the low-
erclamp (C) under shaft and tighten with 2 screws (D).
3. Install the J handle (A) on the middle clamp housing,
then put the upper clamp (C) over J-handle and tighten
the other 2 screws (D).
4-3. BLADE GUARD INSTALLATION
(MT3075/MT30775)
1. Remove gear collar (A) from the threaded gear housing
shaft (Figure 4-3A).
2. Place the shield on the gear housing and align the
mounting holes. Insert screws (B), found in the hard-
ware bag as shown in illustration and tighten securely
(Figure 4-3B).
3. Reinstall the gear collar (A). Ensure the collar spacer
(C) is in place or the collar will rub the gear housing
(Figure 4-3A).
4-4. DEBRIS SHIELD (MT3090/MT30790)
1. Remove gear collar (A) from the threaded gear housing
shaft. Insure collor spacer (C) is in place (Figure 4-4A).
2. Install debris shield with 3 screws (B) provided in the
hardware bag. (Figure 4-4B)
4-1A
4-3A
5
12. DO NOT operate your unit near or around flammable
liquids or gases whether in or out of doors. An explo-
sion and/or fire may result. Never start or run the unit
inside a closed room or building, breathing exhaust
fumes can kill.
13. DO NOT USE ANY OTHER CUTTING ATTACH-
MENT. Use only McCulloch replacement parts
and accessories, which are designed specifically to
enhance the performance and maximize the safe
operation of our products. Failure to do so may cause
poor performance and possible injury. Use only the
stringhead supplied with this product.
Do not use any
other cutting attachment
. Use of such attachments
will void your factory warranty and could result in
serious bodily injury. (Model MT3075, MT3090)
2 - SAFETY PRECAUTIONS
Use of these personal safety items is highly rec-
ommended to reduce the risk of accidental injury.
Minimum operating distance
3-4.INTERNATIONAL SYMBOLS
Read the User Manual.
Pump the primer bulb 10 times.
A
B
C
D
4-2A
B
C
A
C
D
D
E
4-3B
A
C
B
4-4A
4-4B
A
C
B
To Next Page
Loading...
