Page 15@+-*)/93='91<*A,/()'+=(B*4</1(/*91<<*CD###D#!!D$%E%6Item 64857
FG@;HIJK;LGHMJNOGMNH;NGNP; MNFHGQQGHMJN
J'<*O1'=)/=1=9/
Check the oil periodically for clarity� Replace oil if it appears milky or if debris is present,
or every 6 months, or 100 operation hours, whichever comes first�
Replace the oil more frequently if compressor is used in harsh environments such as high heat or high humidity�
PG[HMJNi**HJ*KL;&;NH*MNf[LI*@LJO*T[LNF2*
G<<+.*G'-*P+:4-/((+-*)+*9++<*0/7+-/*931=8'=8*)3/*+'<6
1� Place a container under the Oil Drain Bolt�
2� Remove the Oil Breather to allow
air flow into the Pump�
3� Remove the Oil Drain Bolt, allowing
the oil to drain into the container�
4� When the oil is completely drained from the Pump,
replace the Oil Drain Bolt�
5� Fill the Pump with new SAE 30W, non-detergent,
Air Compressor Oil to the FULL level
on the Oil Sight Glass (5�6 oz�)�
6� Replace and tighten the Oil Breather�
7� Discard the old oil according to local,
state and federal regulations�
U-1'='=8*O+'(),-/*7-+:*)3/*H1=X
The Moisture Drain is located under the Tank� It must be used daily to release all trapped air and
moisture from the Tank� Doing this will eliminate condensation and prevent tank corrosion�
1� Turn the Power Switch off�
2� Place a collection pan under the Drain Valve�
3� Turn the Drain Valve to open it� Tilt
Compressor forward to drain�
4� When all the pressure and moisture are released,
close the Drain Valve�
G'-*@'<)/-*O1'=)/=1=9/
Check the Air Filter weekly to see if it needs replacement�
Replace the filter more often if compressor is used in dirty environments�
1� Remove the Cover�
2� Remove the Air Filter�
3� Replace with a new Air Filter�
4� Replace the Cover�
To Next Page
Loading...
