Maintenance
If the blade is blunt, it can be sharpened in a specialised workshop. If the blade is damaged
or showing signs of imbalance, it must be replaced.
Carry out the following steps to change the blade:
• Turn the mower over and rest it carefully on its side .
• Use safety gloves and hold the blade rmly. Turn the blade bolt anticlockwise to remove
the blade.
• Install the new blade in the reverse order. Ensure that the blade is positioned correctly
and the screw tightened rmly. The blade’s wings should be angled upwards (towards the
mower).
• Tighten the fastening bolt. The tightening torque should be approx. 25 Nm.
IMPORTANT! Always wear safety gloves when engaging in any maintenance work.
Only replace the blade with a suitable replacement blade as this will ensure top
performance and safety under all conditions.
Blade Maintenance
To Next Page
Loading...
