McHale
991B
Round Bale Wrapper
16
If plastic film is to be transported on the machine it must only be done so on
the holders provided and secured, if necessary.
Bale lift arm must be in the fully raised position (if fitted).
Transport lock must be fitted while travelling on the road.
Performing Maintenance
Maintenance and repair work on the 991B should always be carried out in
accordance with this manual.
Maintenance and repair work exceeding the content of this manual should
only be carried out by qualified persons or your McHale dealer.
When conducting maintenance work tie long hair behind your head. Do not
wear a necktie, necklace, scarf or loose clothing when you work near the
machine or moving parts. If these items were to get caught, severe injury
could result.
Before working on this machine, such as replacing film rolls, clearing forage
away from any part of the machine, or altering any setting, the operator must
ensure the following:
(a) The tractor has definitely stopped moving
(b) The hand brake is applied
(c) The engine is shut down
(d) The ignition key is removed
(e) Electronic power supply and control box is disconnected
(f) Hydraulic oil supply is switched off
*
It is forbidden to open any safety guards or to carry out any work on the machine, unless
the above specified precautions have been carried out.
When conducting maintenance work always support the machine properly.
Where possible, lower the attachment or implement to the ground before you
work on the machine. If it is not possible to lower the machine or attachment
to the ground, always securely support the machine or attachment. Do not
work under a machine that is solely supported by a jack. Never support the
machine with props that may break or crumble under continuous load.
Never disable any electrical safety circuits, tamper with safety devices or carry
out any unauthorised modification to the machine.
Avoid heating near pressurised fluid lines, as pressurised lines can be
accidentally damaged when heat goes beyond the immediate flame area.
During inspection
If carrying out an inspection during machine operation within the “Danger
Zone” (highly dangerous and NOT recommended!), then there should be a
fully trained and competent second person operating both the tractor and
wrapper controls. If at any time the second operator loses sight of the
inspector, turn off all tractor power immediately! Such inspection should only
be carried out if all guards are fully in place, the machine is on level ground
and a safe distance is kept from any hazards on the machine.
To Next Page
Loading...