To Next Page
W
wfletcherAug 10, 2025
Why is my McHale 995 TSR Stretch Wrapping Systems table stopping in the wrong position?
- DdblairAug 10, 2025
The table might stop in the wrong position due to several reasons. Here's what you can check: * Incorrect magnet settings: Reset the magnets. * Starting position: Ensure you start with the cut & hold at the rear of the machine. * Slow down setting: Adjust the slow down setting in the control box. * Slow speed valve: Check the electrical connections of the slow speed valve. * Slow speed cartridge: Clean any dirt from the slow speed cartridge. * Table rotation speed: Set the table rotation to 10 RPM if the slow speed is set too fast.
General