McHale 995 L+T Square Bale Wrapper
45
Select & set a Bale Counter (A-J)
1. From the working display, press the Display Down (Button 4) once to select To
Change Total
2. Press Enter (Button 3) to move to the To Select Total “X” display
3. Select desired counter (A -J) using the Up and Down Arrows (Buttons 1 & 4)
4. When you reach your desired counter press Enter (Button 3) to select it
5. Press the Up Arrow (Button 1) or ESC (Button 2) once to return to the working
display
Reset the Current Bale Counter (A-J)
1. Press the Up Arrow (Button 1) once, from the working screen
2. The current bale counter total will be displayed
3. Press Enter (Button 3) to reset it
4. Press the Down Arrow (Button 4) or ESC (Button 2) once to return to the
working display
View the Day Total Bale Counter
1. Press the Up Arrow (Button 1) twice, from the working screen
2. The day total counter will be displayed
3. Press the Down Arrow (Button 4) or ESC (Button 2) twice to return to the
working display
Reset the Day Total Bale Counter
1. Press the Up Arrow (Button 1) twice, from the working screen
2. The day total counter will be displayed
3. Press Enter (Button 3) to reset it
4. Press the Down Arrow (Button 4) or ESC (Button 2) twice to return to the
working display
View the Grand Total Bale Counter
1. To view the grand total bale counter, press the Up Arrow (Button 1) three times,
from the working screen
2. The grand total counter will be displayed
3. Press the Down Arrow (Button 4) or ESC (Button 2) three times
8.6.3 Voltage Monitor
The “Expert Series” Electronic Control Box monitors its operating voltage and displays
it during wrapping. If the voltage falls below a safe level “LOW BATT” is flashed on the
display. The usual causes of low voltage are:
A bad battery
A defective charging circuit
Loose or corroded connections
Fuses or a faulty power lead to the control box
To Next Page
Loading...
Need help?
General
