13
How to Operate the HR033
How to Operate HR033
Mute
Press the MUTE push-button to mute audio at the OUT-
PUTS 1 and 2. The TAPE OUTPUTS and HEADPHONES
output are not affected by the MUTE function. The MUTE
LED above the push-button will flash on and off to indicate
that Mute is active. Press MUTE a second time to unmute
audio.
Mono
Press the MONO push-button to combine left and right ste-
reo signals to mono at OUTPUTS 1, 2 and HEAD-
PHONES Outputs.
Input Source Selection
Press any of the six input push-buttons to select a program
source.
Video/Audio Selection
When the optional McIntosh MVS Audio/Video Selector is
added, first press VIDEO, and then the desired push-button
to select any of the five A/V sources connected to the
MVS.
CD/Tape
Use these push-buttons to operate a CD player, CD changer
or tape recorder, when the component is connected to the
C15 with a McIntosh RCT Translator.
Numbered Push-buttons
Press push-buttons 0 through 9 to access tuner station pre-
sets, CD tracks/discs, or operate a McIntosh Home Con-
troller.
Disc and Track
Use the DISC and TRACK push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Use with a McIntosh tuner. Select AM or FM broadcast
band. Press and release SEEK Up or Down to move from
station to station. Press and hold a SEEK push-button to
move continuously from station to station. Press REVIEW
to start the automatic brief audition of each of the presets
stored in the tuner memory. Press REVIEW a second time
to stop on a station preset and exit the Review process.
Volume
Press the Up or Down VOLUME push-button to raise or
lower the listening volume level. The TAPE OUPUTS are
not affected by volume changes.
Amplifier Selection
Press OUTPUT 1 or 2 push-buttons either separately or to-
gether, to control the rear panel OUTPUTS 1 and 2 which
can feed signals to a power amplifier or other accessory
component.
Home
When the optional HC-1 Home Controller is added to the
C15 system, press the SV/HM (Home) push-button to se-
lect the HC-1. Within 5 seconds press one of the numbered
push-buttons to activate a desired relay in the HC-1.
Acc On
Press ACC ON to turn power ON of a McIntosh LV or
DVD Disc Player.
NOTE: When other brands of components are connected with a
McIntosh Remote Control Translator (RCT), refer to the RCT
Ownerîs Manual for further information on alternate HR033
push-button functions.
To Next Page
Loading...
Need help?
General