McIntosh C26

SPEAKER
Main — Switch the MAIN loudspeaker system
ON or OFF without affecting the performance
of REMOTE speakers.
Remote — Switch the REMOTE loudspeaker
system ON or OFF without affecting the per-
formance of MAIN speakers.
HEADPHONE JACK
The output of the power amplifiers must be
properly connected to the C 26 back panel for
program material to be available at the HEAD-
PHONE jack.
SECONDARY CONTROLS
These controls are located behind the front
panel on top of the C 26. They are readily accessi-
ble by depressing the PANLOC buttons and sliding
the C 26 forward on the PANLOC brackets.
CENTER CHANNEL LEVEL
Top of chassis control to adjust the output level
of the left plus right program material at the CEN-
TER CHANNEL output on the back panel.
PHASE CONTROL
Electronically reverse phase in the left channel
to correct "out of phase" program sources.
TRANSISTOR COMPLEMENT
18 silicon-planar transistors, and 3 silicon
diodes.
SIZE: Front panel measures 16 inches wide (40.64
cm) by 5-7/16 inches high (13.81 cm). Chassis
measures 15 inches wide (38.1 cm) by 5 inches
high (12.7 cm) by 13 inches deep (33.02 cm),
including PANLOC shelf and back panel con-
nectors. Knob clearance required is 1½ inches
(3.81 cm) in front of the mounting panel.
FINISH: Front panel is anodized gold and black
with special Mclntosh gold/teal panel nomencla-
ture illumination. Chassis is black.
MOUNTING: Exclusive Mclntosh developed pro-
fessional PANLOC.
WEIGHT: 18 pounds (8.16 kg) net, 33 pounds
(14.97 kg) in shipping carton.
13
MECHANICAL INFORMATION