Need help?Do you have a question about the McIntosh C2700 and is the answer not in the manual?
General| Preamplifier Type | Vacuum Tube |
|---|---|
| Number of Channels | 2 |
| Total Harmonic Distortion | 0.08% |
| Signal to Noise Ratio | 100dB |
| Outputs | 3 (2 Balanced + 1 Unbalanced) |
| High Level Inputs | 6 |
| Frequency Response | 20Hz to 20kHz +0, -0.5dB |
| Digital Audio Inputs | 2 Optical, 2 Coaxial |
| Vacuum Tubes | 6 12AX7A, 2 12AT7 |
| Dimensions | 17-1/2" (44.45cm) width x 7-5/8" (19.4cm) height x 18" (45.7cm) depth |
| Rated Output Voltage | 2.5V Unbalanced, 5V Balanced |
| Maximum Output Voltage | 16V Balanced, 8V Unbalanced |
| Phono Inputs | 1 MC, 1 MM |
| Output Impedance | 100 ohms Unbalanced, 200 ohms Balanced |
| Headphone Output | Yes |
| Type | Preamplifier |
| Gain | 15dB (High Level), 40dB (MM), 60dB (MC) |
Information about copyrights, patents, and licensed technologies.
Details on XLR, Power Control, Data Port, IR, and RS232 connectors.
Details on advanced audio processing and design features.
Identification and explanation of rear panel input/output connectors.
Connecting power control, data ports, and sensor inputs.
Instructions for connecting analog and digital audio sources.
Guidance on connecting USB, HDMI, and Passthru inputs.
Adjusting trim settings and selecting audio outputs via remote.
Guide to customizing operating settings via the front panel display.
Overview of factory defaults, firmware versions, and input settings.
Steps to rename input sources with custom names up to ten characters.
Setting output 1, 2, and headphone mute functions.
Setting up power control triggers for various inputs and functions.
Assigning data ports and selecting Passthru inputs.
Controlling HDMI CEC and AC power for connected devices.
Controlling synchronized video and audio for TV/monitor HDMI input.
Adjusting gain for HDMI, Optical 1, and Optical 2 inputs.
Setting baud rate and managing the front panel IR sensor.
Switching between normal and alternate remote control codes.
Configuring auto power off and resetting settings to factory defaults.
Steps for powering on/off, selecting sources, and adjusting volume.
Overview of trim adjustments including balance for optimal sound.
Adjusting input levels, bass, and treble frequencies.
Managing tone controls, audio modes, and meter illumination.
Adjusting illumination, display brightness, and phono cartridge loading.
Enabling headphone crossfeed for spatial audio.
Muting audio, managing tone controls, and using output 1/2.
Adjusting trim, monitoring meters, Passthru, and headphone use.
Steps for recording and info on digital input sampling frequencies.
Installing drivers and connecting computer via USB for audio playback.
Connecting USB devices and configuring Windows sound settings.
Adjusting USB audio control panel and understanding playback rates.
Performing a microprocessor reset if controls malfunction.
To Next Page
