EasyManuals Logo

McIntosh C2700 User Manual

McIntosh C2700
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
Factory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “FACTORY RE-
SET, (Hold INPUT)” appears on the Information
Display. Refer to figure 54.
3. Press and hold in the INPUT Control until “FAC-
TORY RESET, In Progress!” appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 55 and 56.
4. Press the Front Panel STAND/BY Push-button to
switch the C2700 on.
Figure 56
FACTORY RESET
Completed!
Figure 54
FACTORY RESET
(Hold INPUT)
Figure 55
FACTORY RESET
In Progress!
Setup, con’t
Power Mode
The C2700 incorporates an Auto Off Feature, which
automatically places the Preamplifier into the Power
Saving Standby/Off Mode. This occurs approximately
30 minutes after there has been an absence of user ac-
tivity (includes changes to any of the Operation Func-
tions such as source selection, volume adjustment,
etc.) or absence of an audio signal. If it is desirable to
disable the Auto Off Feature perform the following
steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “SETUP: Auto
Off, Enabled” appears on the Information Display.
Refer to figure 52.
3. Rotate the VOLUME (ADJUST) Control to select
“Disabled”. Refer to figure 53.
Figure 52
SETUP: Auto-Off
Enabled
Figure 53
SETUP: Auto-Off
Disabled

Table of Contents

Other manuals for McIntosh C2700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McIntosh C2700 and is the answer not in the manual?

McIntosh C2700 Specifications

General IconGeneral
Preamplifier TypeVacuum Tube
Number of Channels2
Total Harmonic Distortion0.08%
Signal to Noise Ratio100dB
Outputs3 (2 Balanced + 1 Unbalanced)
High Level Inputs6
Frequency Response20Hz to 20kHz +0, -0.5dB
Digital Audio Inputs2 Optical, 2 Coaxial
Vacuum Tubes6 12AX7A, 2 12AT7
Dimensions17-1/2" (44.45cm) width x 7-5/8" (19.4cm) height x 18" (45.7cm) depth
Rated Output Voltage2.5V Unbalanced, 5V Balanced
Maximum Output Voltage16V Balanced, 8V Unbalanced
Phono Inputs1 MC, 1 MM
Output Impedance100 ohms Unbalanced, 200 ohms Balanced
Headphone OutputYes
TypePreamplifier
Gain15dB (High Level), 40dB (MM), 60dB (MC)

Related product manuals