McIntosh C47 Connection Diagram

C47 Audio Preamplifier Passthru Connection Diagram
2A
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04157400
Note: Refer to the C47 Owner’s Manual page 9 for additional connection information.
Connection Legend:
Data Cable*- Digital Signal Cable -
Sensor/Keypad Cable - RS232 Cable -
Power Control Cable* - Ground Wire -
Audio Signal Cable - AC Power Cords -
Video Signal Cable - Loudspeaker Cable -
RF Signal Cable -
* 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
Connect to
AC Outlet
A/V Processor
Power Amplifier (Left Channel) - Main Room
(Partial View)
Power Amplifier (Right- Channel) - Main Room
(Partial View)

McIntosh C47 Specifications

General

Type	Solid State Preamplifier
Total Harmonic Distortion	0.003%
Power Consumption	30 watts
Frequency Response	20Hz - 20kHz (+0, -0.5dB)
Phono Stage	Yes
Digital Inputs	2 Coax, 2 Optical, 1 USB
USB Input	Yes
Headphone Output	Yes
Weight	25 lbs (11.3 kg)
S/N Ratio	100dB
Signal to Noise Ratio	100dB (Line), 80dB (Phono)
Gain	15dB (High Level), 40dB (Phono)
Output Impedance	200 Ohms
Inputs	1 Balanced, 3 Unbalanced, 1 Phono MM
Dimensions	17-1/2" (44.45cm) wide, 6" (15.24cm) high (including feet), 18" (45.72cm) deep (including front panel and cables)