Need help?Do you have a question about the McIntosh C46 and is the answer not in the manual?
General| Type | Preamplifier |
|---|---|
| Number of Channels | 2 |
| Frequency Response | 20 Hz to 20 kHz |
| Total Harmonic Distortion | 0.005% |
| Signal-to-Noise Ratio | 100 dB |
| Signal to Noise Ratio (MM) | 80 dB |
| Signal to Noise Ratio (line) | 100 dB |
| Input Sensitivity | 250mV |
| Dimensions (mm) | 445 x 152 x 445 |
| Inputs | 1 x Phono |
| Dimensions (alt) | 17.5" W x 6" H x 17.5" D |
Warnings to reduce the risk of fire or electrical shock by avoiding exposure to rain or moisture and not opening the unit.
Instructions to refer all servicing to qualified personnel and not to open the unit.
Details on XLR, Power Control, Trigger, and Data Port connectors, including pin configurations and usage.
Highlights key features like balanced I/O, precision volume control, tone controls, display, and input switching.
Using TRIM and LEVEL buttons to adjust input sound levels for matching sources.
Using the POWER switch and STANDBY/ON button to turn the unit on or off, and remote power control.
Adjusting the balance between left and right channels for equal listening volume, indicated on the display.
Making tape recordings using separate RECORD and LISTEN controls, and monitoring signals.
Resetting the unit's microprocessors by power cycling and pressing specific buttons.
Performing a factory default reset by holding Listen and OUTPUTS 2 buttons.
Technical details including frequency response, distortion, signal-to-noise ratio, output voltage, impedance, sensitivity, and power requirements.
To Next Page
