Need help?Do you have a question about the McIntosh C52 and is the answer not in the manual?
General| Type | Solid State Preamplifier |
|---|---|
| Total Harmonic Distortion | 0.005% |
| S/N Ratio | 100dB |
| Digital USB Input | 1 |
| Digital Coaxial Input | 2 |
| Digital Optical Input | 2 |
| Digital MCT Input | 1 |
| Home Theater PassThru | Yes |
| Signal to Noise Ratio | 100dB |
| Power Consumption | 50 watts |
| Dimensions | 17-1/2 inches (44.5 cm) wide, 6 inches (15.2 cm) high (including feet), 18 inches (45.7 cm) deep (including front panel and cables) |
| High Level Inputs | 8 |
| Phono Inputs | 1 Moving Magnet, 1 Moving Coil |
| Headphone Output | Yes |
| Gain | 15dB |
| Frequency Response | +0, -0.5dB from 20Hz to 20kHz |
Pin configuration for XLR Balanced Input and Output Connectors.
Connectors for Power On/Off signals and trigger functions.
Connectors for remote control signals to source components.
Connector for external IR receivers to the C52.
Cable for RS232 data port connection to a sub miniature DB9 connector.
Options for switching inputs on/off and renaming them, including custom naming up to ten characters.
To Next Page
