Need help?Do you have a question about the McIntosh C50 and is the answer not in the manual?
General| Signal to Noise Ratio | 100dB |
|---|---|
| Output Impedance | 200 ohms |
| Power Consumption | 50 Watts |
| Frequency Response | 20Hz to 20, 000Hz +0, -0.5dB |
| Total Harmonic Distortion | 0.002% |
| Dimensions | 17.5" (44.45cm) x 6" (15.24cm) x 18" (45.72cm) |
| Maximum Output Voltage | 16V RMS (Balanced), 8V RMS (Unbalanced) |
| Gain | 15dB |
| Phono Input Impedance | 47K Ohms |
| Inputs | 6 (including phono) |
| Outputs | 3 unbalanced, 2 balanced |
Essential safety instructions to prevent electrical shock, fire hazards, and ensure proper operation of the equipment.
Detailed overview of front panel buttons, meters, display, and jacks.
Step-by-step guide to access and operate the C50's setup mode.
Chart of default settings and page numbers for quick reference.
Checking firmware version and reassigning source inputs to different connectors.
Practical examples for reassigning tuner and server inputs to various connectors.
Adjusting input level trims to match volume levels between sources.
Configuring the C50 for multichannel audio integration via passthru.
Selecting a balanced input connector for the passthru mode.
Configuring trigger outputs for remote commands or input selections.
Switching remote control code sets to avoid interference.
Overview of trim adjustments stored per input source for fine-tuning.
Resetting microprocessors and restoring all settings to factory defaults.
Frequency response, distortion, output levels, sensitivity, and noise ratios.
To Next Page
