McIntosh C50 User Manual

10
Displays On Screen Functions on the
McIntosh Music Server and a variety
of other McIntosh Components
Remote Control Push-Buttons
Press to Power the C50 ON
Selects one of the eight
available Audio Sources
Selects a Disc Player, Music Server
or Recorder Function. Seek Sta-
tions Up or Down the AM/FM Dial.
Select AM/FM Station Presets and
performs various functions on a
variety of McIntosh Components
Use to select tuner presets, disc
tracks or any numbered operation
Mutes the audio
Adjusts the volume level up or down
Selects On Screen Functions on a
variety of McIntosh Components
Selects AM Tuner Operating
Functions and Disc Selection on
certain McIntosh Disc Players
Selects FM Tuner Operating Func-
tions and Track Selection on certain
McIntosh CD Players
Press to change broadcast bands on
an external McIntosh Tuner con-
nected. Select certain functions on a
variety of McIntosh Components
Switches the Trigger 1 and/or 2
Power Control Jack(s) On/Off, refer
to “Setup, Power Control TRIG 1
and TRIG 2” on page 15 for addi-
tional information
Note: Push-buttons whose function is not identified above are for use with other McIntosh Products.
LED illuminates during the time a
remote command is sent to the C50
Press TRIM and then the LEVEL
Push-buttons to select and adjust
various functions
Selects Functions as a “shift” key
when used with the AM or FM
push-buttons to select Output 1
or 2
Press to Power the C50 OFF
Scrolls through the
available C50 Inputs
Scrolls through the
available C50 Inputs

McIntosh C50 Specifications

General

Signal to Noise Ratio	100dB
Output Impedance	200 ohms
Power Consumption	50 Watts
Frequency Response	20Hz to 20, 000Hz +0, -0.5dB
Total Harmonic Distortion	0.002%
Dimensions	17.5" (44.45cm) x 6" (15.24cm) x 18" (45.72cm)
Maximum Output Voltage	16V RMS (Balanced), 8V RMS (Unbalanced)
Gain	15dB
Phono Input Impedance	47K Ohms
Inputs	6 (including phono)
Outputs	3 unbalanced, 2 balanced