11
How to use the Remote Control
How to use the Remote Control
The supplied HR072 Remote Control is capable of
directly controlling the functions of contemporary
Source Components connected to the C50 via the Data
Ports.
Note: If at any time the C50 seems unresponsive to
HR072 Remote Control Commands press the
Push-button first.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Note: When the C50 is Off, pressing one of the Source
Push-buttons will switch the C50 On and it will go
to that Input.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The word MUTE
will appear on the Front Panel Information Display.
To un-mute the audio, press the MUTE Push-button
again.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner sta-
tion presets, tracks on discs or selections on a Music
Server.
Disc and Track
Use the AM (disc) and FM (track) Push-buttons when
a Disc Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Up p
or Down q Push-button to seek the next available
station. Press and hold a Channel Up p or Down q
Push-button to seek continuously from station to sta-
tion.
Volume
Press the Up p or Down q VOLUME Push-button to
raise or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are
not affected by volume changes.
Pause
Press the Pause Push-button to perform various
functions on a variety of McIntosh Components. It
will also pause the playing of a disc or tape player.
Trim
Press the TRIM Push-button until the desired Trim
function (Balance, Trim Level, etc.) appears on the
Front Panel Information display, then press the LEV-
EL Up p or Down q Push-button to adjust the Trim
setting.
Note: Press the TRIM Push-button to recall the last Trim
function selected. For additional information on
the Trim Functions refer to pages 18, 19 and 20.
Amplifier Selection
Press the BLUE (Setup) Push-button followed by the
AM (Output 1) or FM (Output 2) Push-button, to con-
trol the rear panel Audio OUTPUTS 1, 2 (ON or OFF)
and Power Control OUTPUT 1 / OUTPUT 2. These
OUTPUTS provide signals to a Power Amplifier or
other accessory component.
To Next Page
Loading...
Need help?
General
