McIntosh C52 User Manual

31
Packing Instructions
Packing Instructions
In the event it is necessary to repack the equipment for
shipment, the equipment must be packed exactly as
shown below. It is very important that the four plas-
tic feet are attached to the bottom of the equipment.
This will ensure the proper equipment location on the
bottom pad. Failure to do this will result in shipping
damage.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition. If
a shipping carton or any of the interior part(s) are
needed, please call or write Customer Service Depart-
ment of McIntosh Laboratory. Refer to page 3. Please
see the Part List for the correct part numbers.
Quantity Part Number Description
1 033888 Shipping carton only
4 033887 End cap
1 033697 Inside carton only
1 034414 Top pad (foam)
1 034301 Bottom pad
4 017937 Plastic foot
4 400159 #10-32 x 3/4” screw
4 404080 #10-7/16” Flat washer
( )

McIntosh C52 Specifications

General

Type	Solid State Preamplifier
Total Harmonic Distortion	0.005%
S/N Ratio	100dB
Digital USB Input	1
Digital Coaxial Input	2
Digital Optical Input	2
Digital MCT Input	1
Home Theater PassThru	Yes
Signal to Noise Ratio	100dB
Power Consumption	50 watts
Dimensions	17-1/2 inches (44.5 cm) wide, 6 inches (15.2 cm) high (including feet), 18 inches (45.7 cm) deep (including front panel and cables)
High Level Inputs	8
Phono Inputs	1 Moving Magnet, 1 Moving Coil
Headphone Output	Yes
Gain	15dB
Frequency Response	+0, -0.5dB from 20Hz to 20kHz