24
Source Selection
Rotate the INPUT Control to select the desired source
or press the INPUT Upp or Downq Push-button on
the Remote Control. Refer to figures 50 and 53.
Volume Control
Rotate the Front Panel VOLUME Control or use the
VOLume Upp or Downq Push-buttons on the Re-
mote Control for the desired listening level. Refer to
figures 50 and 53.
Trim Functions
The MA7200 has various Trim Selections with
Adjustments. The Trim Functions include Balance,
Input Trim Level, Tone Controls, Bass, Treble, Phono
Power On and Off
The Red LED above the STANDBY/ON Push-button
lights to indicate the MA7200 is in Standby mode.
To switch ON the MA7200, Press the STANDBY/ON
Push-button on the Front Panel or press the (Power
- Green) Push-button on the Remote Control. The
MA7200 will go through a brief startup initialization
with the Front Panel Display indicating Power Guard
is active, last used source and volume setting. This is
followed by the volume setting indication starting at
zero and then increasing to the last used volume set-
ting. Refer to figures 50, 51, 52 and 53. To switch OFF
the MA7200, press the STANDBY/ON Push-button on
the Front Panel or the (Power - Red) Push-button on
the Remote Control.
Note: For an explanation of the Remote Control
Push-button functions, refer to pages 14 and 15.
Cartridge MC Loading (when the
Input is Selected), Mono/Stereo,
Meter Backlight, Display Bright-
ness and HXD Mode (when Head-
phones are connected). The Trim
Settings are stored in memory in-
dependently for each Input Source
Selected, except the Meter Illumi-
nation and Digital Audio Display
settings of On or Off, which are
the same for all inputs.
Note: Selection and Adjustment of
all Trim Functions may be
performed by pressing the
Front Panel INPUT Trim
Control and then rotat-
ing it to select the desired
Trim Function. Then use the
VOLUME Adjust Control to
change the setting. Remote
Control TRIM Push-Button
together with the LEVEL UP/
Down Push-button may also
be used. Refer to figures 50
and 53.
After approximately 5 seconds
the Display returns to indicate
the Source Selection and Volume
Level.
BALANCE
Listening balance varies with
different program sources, room
acoustics and listening positions
relative to the Loudspeakers. Use the Balance (Trim
Function) as needed to achieve approximately equal
How to Operate the MA7200
Figure 50
Figure 51
BAL 15%
Figure 52
COAX 1 30%
48kHz
Figure 53
USB 35%
DSD256
To Next Page
Loading...
