Need help?Do you have a question about the McIntosh Power Amplifier MC303 and is the answer not in the manual?
General| Number of Channels | 3 |
|---|---|
| Total Harmonic Distortion | 0.005% |
| Input Sensitivity | 1.0V |
| Power Output per Channel | 300 watts |
| Rated Power Band | 20Hz to 20kHz |
| S/N below rated output | > 100 dB |
| Voltage Gain | 26 dB |
| Signal to Noise Ratio | > 100 dB |
| Damping Factor | >40 |
| Dimensions | 17.5 x 7.6 x 19.5 inches |
| Power Requirements | 120V, 60Hz |
Warnings about uninsulated voltage, rain, and moisture exposure.
Prohibition of opening the unit and requirement for qualified personnel for servicing.
18 key safety instructions for operating and maintaining the equipment.
300W per channel output with Thermal Trak transistors for low distortion.
Patented circuit to prevent amplifier clipping and protect loudspeakers.
Protection circuits ensuring long operating life and preventing overheating.
Autoformers for optimal speaker load matching and DC protection.
Explanation of the three power output meters.
Indicators showing the status of the Power Guard circuits.
How to turn the amplifier on manually or via remote signal.
How Power Guard indicators work and protection during overheating.
Details on advanced transistors for accurate temperature monitoring.
The role of Autoformers in impedance matching and loudspeaker protection.
Benefits of Autoformers for matching and protecting speakers.
The output transistor protection circuit for safe operation.
How Power Guard eliminates clipping distortion and its impact.
Specifications for power output, load impedance, and rated power band.
Technical specs for THD, dynamic headroom, and frequency response.
Specifications for input sensitivity and signal-to-noise ratio.
To Next Page