IM 950-1 / Page 24 of 38
3.1 The touchpad of the electronic controller can be
programmed for four time periods, MORN,
DAY, EVE, and NITE that are customizable for
each day of the week. Each period will have a
start time, heat and cool temperatures. The unit
will monitor the day and time, while maintaining
the specic conditions for each period of the
day. During programming, the item that is
ashing is adjustable.
3.2 T
o enter the program menu, press SLEEP ( )
and MODE (
) buttons for 5 seconds.
3.3 By pressing SLEEP (
) display will show
the day screen as shown below. Press
or
button to change the day to program. To advance
to the next screen, press SLEEP (
) button. To
return to the previous screen, press MODE (
)
button.
3.4 By pressing
or button, the period of the
day will change.
3.5 T
o advance to the next screen, press SLEEP
(
) button. Starting time will ash.
Adjust the starting time by pressing
or
buttons.
3.6 To advance to the next screen, press SLEEP
(
) button. Heat temperature will be
displayed. Adjust the heat setting with
and
buttons.
3.7 T
o advance to the next screen, press SLEEP
(
) button. Cool temperature will be
displayed. Adjust the cool setting with
and buttons.
3.8 T
o program the thermostat for each period of the
day, repeat steps 3.3 through 3.7.
Further
, the thermostat can be programmed for
each individual day of the week or use the
Simpleset
TM
feature as described below.
3.9 Simpleset programming is a convenient method
of programming the thermostat. Once the entire
Monday (Day 1) schedule is set, Simpleset
programming will copy the Monday schedule to
every day of the week. After completing
Monday schedule, “day 2” will appear on
the screen. Press Down button once to get
to “day 1.” By pressing Down button for 3
seconds, days of the week will count down from
7 to 1 and settings are memorized. Once the
schedule is locked in, go through each day of the
week and make changes as needed.
This feature
speeds up the programming of the standard
weekday/weekend schedule.
3.10 T
o exit the program mode, press MODE ( )
and SLEEP (
) buttons simultaneously for 5
seconds.
3.11 After exiting the program mode, select the mode
of operation and activate the program mode by
pressing the PROG ON/OFF button.
After a power outage, programmed daily settings will be
retained in memory. However, the clock must be reset
to the current time for the programmed daily settings to
resume the correct schedule of operation. See Clock Set
Menu instructions to reset the time and day of week.
Controls
Premium Digital Touchpad Control
NOTICE
78
o
70
o
To Next Page
Loading...
Need help?
General
