12
Appendix B (continued)
1.2. Manually Turning On and Off a Magnum Relay Output
Use the up and down arrow keys to cycle through the three modes for the relay output:
AUTO, MANON or MANOFF
Stop when you reach the one you want:
Finally, press the Enter key to make the change. In our example the relay
output is now manually turned on as shown here:
Remember to return the relay output to AUTO mode when you are done!
09:56 Outputs
Relays Status
M-1 COMP1-1 Off.
M-2 LOAD1-1 Off
M-3 UNLOD1-1 Off
M-4 LLS1-1 Off
Anlog PG PG
Change Made
09:56 Outputs
Relays Status
M-1 COMP1-1 Off.
M-2 LOAD1-1 Off
M-3 UNLOD1-1 Off
M-4 LLS1-1 Off
Anlog PG PG
COMP1-1
Manual MANON
Status
To Next Page
Loading...
Need help?
General
