P
H
50
33-MAINTENANCE AND CLEANING
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
Cleaning the ash collection compartment
To clean the ash collection compartment, extract the ash pan “P”. Wipe away any residual ash before reinserting the pan. Your experience
and the quality of the pellets used will determine the ash pan cleaning frequency.
However, it is recommended not to exceed 2 or 3 days.
Caution! When cleaning is completed, remember to place back the ash pan “P”, insert the brazier “b” and close the rebox
door.
Cleaning the top calorite
To guarantee correct operation, every 2/3 months,it
is necessary to clean the holes in the top calorite
“H” with a brush or with the supplied cold handle.
To Next Page
Loading...
