MDS E-PGM+ - Writing Errors and Solutions - Part 2; Common Writing Errors (Part 2)

MDS
18
8-1. Info. : Error message at writing
Error message Error and reason
Debug Power
Request Fail
The reset ic in the board is in reset state.
If tool-Vdd is lower than the Vdd of reset IC.
Ex) Tool Vdd : 3.3V, Reset IC : 4.2V
As the default voltage is 3.3V, need to change Vdd from 3.3V to 4.5V
CPU Reset
Halt target
Device is in reset state.
Check LVD of user option, especially A31G112/123.
Set VDD as higher than LVD level.