Mebay DC5 D MK3 Series User Manual

DC5xD MK3 GENSET CONTROLLER USER MANUAL
31
19: 200-0Ω
14
Action if RPM
lost
Warning/Alarm and stop
The flywheel teeth is not 0 to detect this
fault.
15
Action if low oil
pressure
Warning
Alarm and stop
If setting as warning,the AUX. INPUT
should be set as Low oil pressure stop
disabled and input is valid. When the oil
pressure value is lower than the preset
value or low oil pressure alarm input
signal is valid, then controller only
display warning but not stop.
16
Action if high
temperature
Warning
Alarm and stop
Alarm and stop after
unloading
Alarm and stop: when the temperature
is higher than preset value or high
temperature signal is valid, then
controller will alarm and stop after
normal faults delay.
If setting as warning:the AUX. INPUT
should be set as high temperature stop
disabled and input is valid. When the
temperature value is higher than the
preset value or high temperature alarm
input signal is valid, then controller only
display warning but not stop.
If setting as alarm and stop after
unloading:the AUX. INPUT should be
set as high temperature stop and input
is valid. When the temperature value is
higher than the preset value or high
temperature alarm input signal is valid,
then controller shall start the unloading
procession and stop with alarm.
17
Action if oil
pressure
sensor
disconnected
Disable
Warning
Alarm and stop
Action if oil temperature sensor
disconnected.
18
Action if
temperature
sensor
disconnected
Disable
Warning
Alarm and stop
19
Action if fuel
Level
sensor
disconnected
Disable
Warning
Alarm and stop
Action if Fuel level sensor disconnected.
20
Pressure/Temper
ature unit
℃/KPA
℃ /BAR
℃/PSI
℉/KPA
℉/BAR
℉/PSI
Unit display.
2)Basic Setting 2

Mebay DC5 D MK3 Series Specifications

General

Brand	Mebay
Model	DC5 D MK3 Series
Category	Controller
Language	English