Page 23 SE
AC
Slab Series - Service & Parts Manual
March 2022Section 10 - Maintenance
ELECTROCUTION / BURN HAZARD. CONTACT WITH ELECTRICALLY
CHARGED CIRCUITS COULD RESULT IN DEATH OR SERIOUS INJURY.
REMOVE ALL RINGS, WATCHES AND OTHER JEWELRY.
Inspect the following areas for burnt, chafed, corroded and loose wires:
Ground control panel
Control Module
Battery Module
Platform controls
Scissor control cable
Turn the key switch to ground control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls
Set the Maintenance Locks (see the Introduction portion of this manual).
DEATH OR SERIOUS INJURY HAZARD!
NEVER PERFORM WORK OR INSPECTION ON THE MACHINE WITH
THE PLATFORM ELEVATED WITHOUT FIRST BLOCKING THE SCISSOR
ASSEMBLY WITH THE MAINTENANCE LOCK.
Inspect the center chassis area and scissor arms for burnt, chafed and pinched cables.
Inspect the following areas for burnt, chafed, corroded, pinched and loose wires:
Scissor arms
ECU to platform controls
Power to platform wiring
Inspect for a liberal coating of dielectric grease in the following locations:
Between the ECU and platform controls
All wire harness connectors Level sensor
Raise the platform and return the Maintenance Locks to the stowed position (see the
Introduction portion of this manual).
Lower the platform to the stowed position and turn the machine off.
Tires & Wheels
Maintaining the tires and wheels in good condition is essential to safe operation and good
performance. Tire and/or wheel failure could result in a machine tip-over. Component damage may
also result if problems are not discovered and repaired in a timely fashion.
Check the tire surface and sidewalls for cuts, cracks and unusual wear.
Check each wheel for damage, bends and cracks.
Check each wheel bolt for proper torque
(38 ft-lbs/51 Nm dry) (1930SE)
(65 ft-lbs/88 Nm dry) (2632SE , 3346SE, 4046SE , 4555SE)
1.
•
•
•
•
•
2.
3.
4.
5.
•
•
•
6.
•
•
7.
8.
1.
2.
3.
•
•
To Next Page
