Page 21 SE
AC
Slab Series - Operator’s Manual
November 2022Section 7 - Operating Instructions & Functions Test
Operation from Ground
Drive and steer functions are not available from the ground controls.
1. Turn the Key Switch to ground control.
2. Pull or turn the red Emergency Stop button clockwise to the on position at
both the ground and platform controls.
3. Be sure the battery pack is connected before operating the machine.
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine.
To Position Platform
Press the blue up arrow to raise the platform.
Press the yellow down arrow to lower the platform.
Operation from Platform
1. Turn the Key Switch to platform control.
2. Pull or turn the red Emergency Stop button clockwise to the on position at
both the ground and platform controls.
3. Be sure the battery pack is connected before operating the machine.
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine.
ART_5020
Control Handle
To Position Platform
1. Press the lift function select button.
2. Press and hold the Function Enable Switch on the control handle.
3. Pull the control handle upward to raise the platform.
4. Push the control handle downward to lower the platform.
To Next Page
Loading...
