page 25
To set SEND MEM, move the arrow cursor against it in
COMMS sub-menu 1 and press the ENTER key. This will
cause a TX symbol to flash in the main display as the
memory data is now transmitted to a peripheral device.
The data is transmitted at the settings defined by PORT.
After transmission of data you will now return to COMMS
sub-menu 1.
To set CLEAR MEM, move the arrow cursor against it in
COMMS sub-menu 1 and press the ENTER key. This now
erases all the data stored in the memory. The memory
counter is now reset to zero. After clearing the memory you
will now return to COMMS sub-menu 1.
Press the ESC key to return to page 2 of the main-menu,
and again to return to the main display.
SEND FROM MEMORY
C
LEAR THE MEMORY
To Next Page
Loading...