MECNOSUD SP80 - 4.5.2 Manual Mode at 2 nd Speed; 4.6 Automatic Mode; 4.6.1 Automatic Mode

To Next Page

To Previous Page

ALTERNATIVELY, PROCEED AS FOLLOWS:

1. Position the selector Pos.6 (Pict. 3.1) in position ON

2. Rotate the Timer 1 knob to the M position (manual)

3. Decide the bowl rotation direction with the selector Pos.9 Pict. 3.1 (otherwise the bowl does not rotate)

4. Press the START button (Pos 5 - Pict. 3.1) to start with the 1

speed

5. Press the STOP button (Pos 8 - Pict. 3.1) to stop the working cycle.

NOTE: During the working cycle it is possible to reverse the rotation direction of the bowl through the

selector Pos. 9 (Pict. 3.1).

4.5.2 MANUAL MODE AT 2

SPEED

To work in manual mode at 2

speed, proceed as follows:

1. Position the selector Pos.6 (Pict.3.1) in position ON

2. Rotate the Timer 1 knob to the E position (Timer 1 excluded)

3. Rotate the Timer 2 knob to the M position (manual)

4. Turning the selector switch Pos. 9 (Pict.3.1) to the right (otherwise the bowl does not rotate)

5. Press the START button (Pos 5 - Pict.3.1) the machine start at 1

speed and switches automatically to

the 2

speed after about 5 seconds

6. Press the STOP button (Pos 8 - Pict.3.1) to stop the working cycle

NOTE: It is not possible to reverse the rotation direction of the bowl when the machine is operating in 2

speed

4.6 AUTOMATIC MODE

4.6.1 AUTOMATIC MODE – ONE SPEED

To work in automatic mode at 1

speed, proceed as follows:

1. Position the selector Pos.6 (Pict.3.1) in position ON

2. Rotate the Timer 1 knob clockwise (to the right) to desired time period

3. Rotate the Timer 2 knob clockwise (to the right) to the E position (Timer 2 excluded)

4. Decide the bowl rotation direction with the selector Pos.9 –Pict. 3.1 (otherwise the bowl does not rotate)

5. Press the START button (Pos 5 - Pict. 3.1) to start at 1

speed.

The machine will stop when the time has ended.

MECNOSUD SP80 - 4.5.2 Manual Mode at 2 nd Speed; 4.6 Automatic Mode; 4.6.1 Automatic Mode - One Speed