MECNOSUD SP80 - 4.6.2 Automatic Modo

To Next Page

To Previous Page

NOTE: Through the selector Pos 9(Pict. 3.1), it is possible to reverse the rotation direction of the bowl.

To work in automatic mode at 2

speed, proceed as follows:

1. Position the selector Pos.6 (Pict.3.1) in position ON

2. Rotate the Timer 1 knob clockwise (to the right) to the E position (Timer 1 excluded)

3. Rotate the Timer 2 knob clockwise (to the right) to desired time period

4. Turning the selector switch Pos. 9 (Pict.3.1) to the right (otherwise the bowl does not rotate)

5. Press the START button (Pos 5 - Pict.3.1) to start the machine; it starts with the 1

speed and switches

automatically to the 2

speed after about 5 seconds

The machine will stop when the time has ended.

NOTE: It is not possible to reverse the rotation direction of the bowl when the machine is operating in 2

speed

4.6.2 AUTOMATIC MODO- TWO SPEEDS

1. Position the selector Pos.6 (Pict.3.1) in position ON

2. Rotate the Timer 1 knob clockwise (to the right) to desired time period

3. Rotate the Timer 2 knob clockwise (to the right) to desired time period

4. Decide the bowl rotation direction with the selector Pos.9 – Pict.3.1 (otherwise the bowl does not rotate)

5. Press the START button (Pos 5 - Pict.3.1) to start the machine

When the time on the display of Timer 1 reaches the 0 , the machine switches automatically to the 2

speed

and it will stop when the time has ended.

NOTE: It’s possible to reverse the rotation direction of the bowl when the machine is operating in 1

speed

NOTE: When the machine is operating in 2nd speed, the bowl rotates only if the selector switch Pos. 9

(Pict.3.1) is turned to the right.

NOTE: It is not possible to reverse the rotation direction of the bowl when the machine is operating in 2nd

speed

MECNOSUD SP80 - 4.6.2 Automatic Modo - Two Speeds