Med-Mizer ActiveCare-Fixed - Specifications

ActiveCare - Fixed
User Manual
MAN-ActiveCare REV02 ActiveCare Fixed USER MANUAL Page 6 of 25
Cleaning Safety
WARNING Do not spill or spray liquid on the bed. Excessive liquid on the bed can
result in an electric shock hazard. In the event of a liquid spill or excessive liquid on the
bed, unplug the bed immediately. Remove excess liquid and allow bed to dry thoroughly
before restoring power.
CAUTION Follow manufacturer’s instructions for proper use of cleaning agent.
Improperly diluted or improperly applied cleaning agents can result in inadequate
disinfection or a caustic burn hazard.
CAUTION Clean the hand control regularly to ensure good hygiene standards.
Maintenance and Service Safety
WARNING Before performing bed maintenance or service, unplug the power cord to
avoid an electric shock hazard.
WARNING If a fault or problem is found during preventative maintenance inspections,
remove the bed from service until the appropriate repair or adjustment is made.
Specifications
“Low” Deck Height Range
12.50”
Maximum Head Angle
58º ± 3º
“High” Deck Height Range
17.50”
Maximum Head Angle(Pivoted)
90º ± 3º
Safe Working Load
600 lbs.
Maximum Knee Angle
29º ± 3º
Overall Bed Widths
36", 42"
Power Requirements
120 VAC, 50 Hz
Overall Bed Length
88.00"
Maximum Current Draw
4.5 amps
Overall Bed Weight
36”: 313lbs
42”: 323lbs
Controller Output Voltage
24 VDC
Overall Bed Weight with
boards
36”: 335lbs
42”: 345lbs