QUICKUSER’SGUIDE
Press the button of the remote control.
Confirmation indicators flashings, signals of the buzzer (with optional
siren), doors locking, windows closing, LED (red pilot lamp) lit fixed, then
flashing with active ultrasonic sensor.
, doors locking, windows closing, LED
immediately flashing indicate the activation without ultrasonic sensor (definitive
cutting out).
the doors locking, the windows closing and the
indicate the activation.
The buttons (instantaneous and/or delayed such as doors, bonnet and boot)
and/or the additional modules read are not included.
Press in fast sequence the button of the remote control.
Confirmation of the direction indicators, signals of the buzzer,
doors locking, LED immediately flashing.
Press the button of the remote control or in fast sequence (only for those cars
where the double manual control opens the driver's door first, and then the passengers' ones).
Confirmation of the direction indicators, signal of the buzzer, doors
opening, LED switched off (with closed doors).
The direction indicators can be connected to give the optical signals when the system alarms.
In some vehicles they can give also the “service signals” and the system “activation /
desactivation” signals in addition to the LED and the or buzzer (optional).
If any anomalies or alarms occurred, the first alarm is shown by some additional signalings
(BEEPS) of the siren and by some LED flashings.
Doors, bonnet, boot opening (connected to the instantaneous input).
Contact key .
Ultrasonic sensor (it detects all kind of intrusions in the vehicle).
Doors, bonnet, boot opening (connected to the delayed input).
Anti-tampering of the ultrasonic sensor (anti-blinding/anti-masking).
Self-diagnosis of the system.
Separated input for additional modules: hyperfrequency, infrared, anti-lifting, shock sensor,
etc.
CurrentAbsorption sensor.
System activation with doors, bonnet and boot buttons cutting out on the instantaneous
input, after denial for open door.
SYSTEM ACTIVATION
SYSTEM DESACTIVATION
BY THE REMOTE CONTROL WITH ULTRASONIC
SENSOR, WINDOWS CLOSING AND ACTIVE OPTIONAL MODULES:
1 time
: 2 direction 2 two-tone
WARNING: 3 flashings, 3 two-tone signals
3 flashes, 3 bi tonal signals,
LED first fixed lighted on, then flashing
2 times
: 4 short flashings 4 two-tone
The cutting out is valid till the following activation.
1 time 2 times
: long flashing 1 extended
WARNING:
SIR 050 SIR 050.NA
1
2 [+15] ON
3
4
5
6
7
8
9
The alarm memory is repeated if the system is activated and desactivated without
turning the contact key on [+15] ON.
It's cancelled only by turning the contact key [+15] ON.
To simplify the use of the system, we always suggest the pairing of the electronic key
WITHOUT ULTRASONIC SENSOR, WINDOWS CLOSING AND OPTIONAL MODULES:
CHD 400 (allowing the system activation/desactivation without the remote control and
the vehicle start if the ANTI-CAR JACKING function is activated).
16
To Next Page
Loading...