1 ON OFF
2
11 times USER'S programming
12 times INSTALLER'S programming
WARNING: Pressing the LED button the BEEP of the buzzer confirms the signal has
been recognized by the central unit.
3
4
5 ON / OFF
WARNING:
USER'S OPTIONAL PROGRAMMINGS
The central unit works even without the a.m. programmings.
Insert and turn the ignition key and one time to switch the LED on.
Before the LED is switched off, press its button to:
- consecutively ( ).
Confirmation: short, low tone BEEP of the buzzer, followed by a very long BEEP and by some
LED flashings.
When the LED is fixed, we are in the programming phase.
- ( ).
Confirmation: short two tone BEEP of the buzzer, followed by some BEEPS combined with
some LED flashings. When the LED is fixed, we are in the programming phase.
Every time the led switches off for confirmation and the buzzer of the siren gives 1 BEEP.
- If the LED switches off autonomously within 2 or 3 seconds, wait for 30 seconds and repeat
the procedure again from point 1.
With the LED lit fixed press its button as many times as the chosen programming (see the
relevant tables).
- On every valid pulse the LED switches off temporarily and the buzzer gives 1 BEEP.
Once terminated the sequence, after some seconds the system signals the programming
has been accepted giving a two tone signal, a series of BEEPS or a musical sequence and
the LED is now lit fixed again.
- Short BEEPS and very quick flashings of the LED indicate a denial: the made programming
does not exist.
Terminate the procedure turning the ignition key one time.
The procedure can be started only if the system is desactivated.
Once entered into the programming mode it is possible to set up in succession more
functions belonging to the same category: user / installer.
The completed and confirmed programmings remain active also when the central unit is not
fed.
The installer can make all the USER/INSTALLER's programmings by means of the special
SK K
r following versions.
!
!
!
!
5 on duty - standard setting
DIRECTION INDICATORS'S FLASHING ACTIVATION/DESACTIVATION
7 Activation - standard setting
ACOUSTIC SIGNALINGS ACTIVATION/DESACTIVATION
9 Activation - standard setting
CUTTING OUT OF THE ADDITIONAL MODULES BY USING THE REMOTE CONTROL
11 Always active / - standard setting
SAFETY LOCK
13 Cutting out - standard setting
ANTI-ACCIDENTAL DESACTIVATION
15 Cutting out - standard setting
17 Cus
1 alarm cycle - standard setting
Out of order /
Cutting out /
Cutting out /
Cut out option
Activation /
Activation /
rm cycles /
IT and a Personal Computer (office or laptop), using the specific
o
MED SOFTWARE
3.2.3
tomising siren sound
BUTTONS INPUT CUTOFF/ACTIVATION
19 Activation - standard setting
21 Activation - standard setting
ALARM CYCLES NUMBER FROM BUTTONS INPUTS
23
Instantaneous input cutoff /
Delayed input - cutoff /
3 ala
23
To Next Page
Loading...