Medion LIFE E62003 - Transmitter Power Connection; Charging the Headphone Battery

55
DE
EN
FR
NL
ES
IT
There is a keyhole hanger on the back of the transmitter for
attaching the device to a room wall.
 Take care to ensure that the keyhole hanger is
positioned with the narrow part pointing upwards.
 Use an appropriate countersunk screw
(e.g. 3.0 mm x 30 mm, not supplied) for wall mounting.
6.2. Power supply (transmitter)
 Connect the supplied mains adapter to the DC IN port
on the transmitter.
 Plug the mains cable into an easily accessible mains
socket (100–240 V~ 50/60 Hz).
6.3. Charging the headphone battery
You can charge the headphone battery either using the
supplied micro USB charging cable or by placing it on the
transmitter.
 Make sure the headphones are switched off and charge
them for at least twohours.
6.3.1. Charging using the micro USB charging
port
 Connect the supplied micro USB cable to the micro USB
charging port on the headphones.
 Connect the other end of the micro USB cable to a USB
power source (5.0 V
500 mA), e.g. on your PC or
notebook.
The charging LED lights up red during charging.
The charging LED turns off once the headphone battery is
fully charged.