17
Setting the norms
The norm determines the value of the angular points
(see chapter “Graphical position indicator” on p. 15). To
record one cycle, the norm value must be reached by
continuous or step-by-step movement in one direction.
If the direction of movement changes before the norm
is reached, the calculation is interrupted and the cycle is
not counted.
Current date and time
Display of the current date and time.
Adjustable system functions
Sleeping time
Setting the countdown time to sleep; see chapter “Home
screen” on p. 12.
Releasing time
Setting the time for the reverse movement to release the
pressure in the system.
Weight limit
Setting the limit of angular velocity at which the motor
braking will be activated when lowering the stretcher.
Set a lower value for braking at lower loads and vice
versa.
Charge limit
Setting the voltage value [mV] at which charging in the
loading device (12V circuit) is initiated.
Pull after 12V unplug
Function for automatic retraction of the undercarriage
after disconnection from the charging connectors in the
loading device (12V circuit).
Auto pull up
Function for automatic retraction of the undercarriage
when the monoblock/chassis rests on the sliding arm of
the loading device.
Motor direction
Setting the direction of motor rotation.
To Next Page
Loading...
