Accessories
Padded backrest, velcro adjustable
Thanks to this Velcro system, you can change the
firmness of the backrest and adjust the comfort of
your wheelchair according to your needs:
remove the padded upholstery, loosen the Velcro bands
at the back of the backrest by simply pulling them
apart. You can then adjust them to suit your back.
Height-adjustable push handles, mounted back
Thanks to its height adjustability, this option
enables your companion to push the wheelchair
comfortably. Because the push handles are set
backwards, the user's shoulders will benefit from
more freedom of movement. This is important for
the mobility and independance of the user.
Height adjustment
Loosen the fastening handle situated on the handle-
supporter, adjust the push handles to the desired
height and tighten the fastening handle firmly.
Armrests, swing-away and height-adjustable
Swing-away
Slighlty raise the armrest and swing it backwards
or, if needed, pull it out completely.
Height-adjustment
Remove the armrest from its socket. Loosen the
screw at the bottom of the armrest (Allen key
4mm). Slide the reinforcement cylinder (situated
inside the armrest tube) to the desired armrest
height. Fit the Allen screw and tighten, before
reinserting the armrest into its socket.
29
Fastening handle
GB
Handle
To Next Page
Loading...
