12
Cup Holder Assembly
.
1. Make sure you have all the necessary pieces.
2. Snap U-shaped clamp onto the tubing of your mobility device
(see Figure A).
Note: Be sure the clamp is positioned in such a way that it allows
the cup to sit level, NOT tilted in a direction that might allow
your drink to spill (see Figure B).
3. Remove the knob from the cup holder, insert holder through
the opening in the clamp, and tighten the knob to assure
that the cup holder stays tightly attached (see Figures C
and D). (Important: Hand Tighten Only!)
Note: If necessary, insert a rubber
sleeve in the clamp to better fit the
size of the tubing. Whether you use a
sleeve or not, the clamp should fit
tightly onto the tubing, otherwise the
cup holder is susceptible to slipping
and spilling your drink, which may
cause injuries.
Enjoy your drink on the go!
To Next Page
Loading...
Need help?
General
