Medline MDS86845BLKM - Brake Handle Assembly; Adjusting Backrest Height

8
MDS86845 (GPI171)
Revised (A): 09/13/2013
Brake Handle Assembly
1. Press and hold the yellow button in (item C in Figure 1 above and Figure 9 below).
2. Insert hand grip into appropriate hole (see Figure 10).
Note: Keep brake cable to the outside of the walker.
3.
Legs
     

    
     
     
     
     
     
Arms
Note: 1 is the highest, 5 is the shortest setting.
Handle Height adjustments (set to Dimension B above):
Figure 9 Figure 10
Adjust the backrest height for comfort:
1. Pull the Backrest Height Adjust Lock (item G in Figure 1 above).
Raise or lower the backrest to desired height.
2. Release the Backrest Height Adjustment Knob. Move backrest


3.
Chart 2