EN
34
against the handle.
FIG. 9
5. The motor stops when the power switch
handle is released.
WARNING!
The blades continue to rotate after the motor
has been switched o.
TIPS
• Do not cut wet grass, it will fasten to the
underside of the deck and prevent the
ejector/catcher from working properly.
• Do not mow more than 1/3 of the height
of the grass at once, this can damage the
grass.
• Adapt your speed of movement so that
the cut grass is spread evenly over the
lawn. Move at a lower speed if the grass is
tall and/or thick.
• Tall grass may need to be mowed twice,
rst cutting 1/3 of the height and then
cutting 1/3 of what is left after mowing
the rst time. Follow a dierent pattern
when performing the second cut. Mow
with overlapping paths.
• Always operate the product at full motor
speed for optimum mowing results.
• Clean the underside of the cutting deck
each time after use, removing any
accumulated grass, which can impair
mowing results.
• Mowing fallen leaves may be benecial
for the lawn. The leaves must be dry and
not lying in an excessively thick layer on
the lawn. Mow several times while the
leaves are falling – don’t wait until all the
leaves have fallen from the trees.
NOTE:
Switch o the motor immediately if the
blades hit any objects. Remove the battery
and check the product for damage. Repair
any damage before using the product again.
In the event of abnormal vibrations, switch
o the product immediately and remove
the battery. Have the product checked and
repaired before using it again.
MAINTENANCE
WARNING!
Switch o the product, remove the battery
and wait until all moving parts have
completely stopped before adjusting and/or
performing maintenance.
• Do not spray water over the product.
The penetration of water can damage
electrical parts. Clean the product with a
dry cloth, brush or the equivalent.
• Do not make any modications to the
product and never try to open or
dismantle it. Have the product checked by
an authorised service centre in the event
of any of the following:
– If the blades strike an object.
– The motor stops suddenly.
– If the blade is bent (do not attempt
to straighten it).
– If the motor shaft is bent (do not
attempt to straighten it).
– If there is a short-circuit/electrical
fault when the plug is inserted.
– If the gearbox is damaged.
– If the V-belt is damaged.
• Only use parts and accessories
recommended by the manufacturer.
BLADES
NOTE:
Wear gloves when handling blades.
• The blades are made of compression-
moulded steel. They need to be
sharpened regularly.
• The blades must always be balanced in
To Next Page
Loading...
