Meec tools 014477 - TROUBLESHOOTING

EN
35
order to avoid harmful vibrations.
• Undo the blade screw to remove the blades.
Check the blades’ balance by inserting a
screwdriver with a round stem (or other
round object) through the hole in the
middle. The blades should hang horizontally
without moving. If they are not balanced,
the heavier end of the blade will drop down.
Sharpen the heavier end until the blades are
balanced. Replace or repair damaged parts.
FIG. 10
• Be sure to t the blades with the edges
pointing in the correct direction of
rotation. Tighten the blades to 20 Nm.
TROUBLESHOOTING
Problem Action
The motor will not
start.
Check that the battery is
charged.
Start the product in short
grass or in an area that has
already been cut.
Clean the outfeed opening
and cover. The blades must
rotate freely.
Adjust to a suitable mowing
height.
Check the motor’s carbon
brushes and replace, if
necessary.
The motor speed
drops.
Adjust to a suitable mowing
height.
Clean the outfeed opening
and cover.
The blades must be
sharpened or replaced
by an authorised service
centre.
Not all the grass
goes into the
catcher.
Adjust to a suitable mowing
height.
Wait until the lawn dries.
The blades must be
sharpened or replaced
by an authorised service
centre.
Clean the grille on the grass
catcher.
Clean the ejector opening/
ap.
Contact an authorised service centre if
the problem cannot be xed by using the
troubleshooting chart.