3.2.4 Power Source Connection :
A. Power Source - This machine is equipped with 3HP main motor and 1HP hydraulic motor ,
and 1/8HP coolant motor. Connect the power supply cable to the circuit breaker(N.F.B.)
terminals. The power supply to your machine should agree with the wring voltage that is
indicated on the label attached to the electrical enclosure and main motor.
B. Earth - Be sure to connect the earth cable to the earth terminal.
C. Starting - After making the necessary wiring connections, turn the power switch on the control
panel clockwise to turn power on, depress the vice limit switch (if necessary, e.g. if there is no
stock bar clamped in the vice) and push the button to see if the saw head moves upward. If the
saw head does not rise , the hydraulic pump motor is rotating in the wrong direction. If the motor
runs in the wrong direction, turn off the power switch and disconnect the power supply cable,
Then interchange any two phase connections.
3 - 4
To Next Page
Loading...