Mega SSC Series - SSC-T Series Specifications; SSC-E Series Specifications; Control Unit Installation Guide

5
SSC-T Series
(Chlorinator with time switch)
SSC-E Series
(Basic Salt Chlorinator)
Installation Guide
Control Unit:
1. Select a convenient well-ventilated location within one meter of filter
equipment.
2. Mount the control unit vertically onto a post or wall 1.5 meters above
ground level.
(Australian Standards requires that the electric control unit shall not be
located within 3 meters of the pool water.)
3. Plug Power supply into a suitable weatherproof outlet
4. Plug pump into the power outlet of the Power Supply Unit. (applicable for
SSC-TLT Series only)
5. The Unit must be kept away from acid and other chemical storage areas.
Acid and chemical vapors will corrode the electronics inside the Unit.
6. It must also be kept away from heat sources.
SSC15-E
SSC25-E
220～250VAC 50/60Hz
100～120VAC 50/60Hz
220～250VAC 50/60Hz
100～120VAC 50/60Hz
100VA
160VA
15g/hr
25g/hr
SSC50-E
220～250VAC 50/60Hz
100～120VAC 50/60Hz
300VA
45g/hr
50000 45000
75000 70000
120000 110000
Model
Salt chlorinator
voltage input/ freq
Cell
Output
Fiberglass
Pool (Litre)
Concrete
Pool(Litre)
Rating (salt chlorinator
and underwater
light transformer)
SSC15-T
SSC25-T
220～250VAC 50/60Hz
100～120VAC 50/60Hz
220～250VAC 50/60Hz
100～120VAC 50/60Hz
100VA
160VA
15g/hr
25g/hr
SSC50-T
220～250VAC 50/60Hz
100～120VAC 50/60Hz
300VA
45g/hr
50000 45000
75000 70000
120000 110000
Model
Salt chlorinator
voltage input/ freq
Cell
Output
Fiberglass
Pool (Litre)
Concrete
Pool(Litre)
Rating (salt chlorinator
and underwater
light transformer)
English