Appendix
Communication Setting With Multiple Brands’ Inverters
1. MEGATRON lithium battery RS485/CAN Communication Cable Order (sequence)
Instruction as below:
2. Dial-up switch settings when PACK is used in parallel
2.1 Different PACK can be distinguished by setting the dialing switch on BMS to avoid setting
the same address. The definition of BMS dial switch refers to the following table;
2.2 RS485 performing muti-machine parallel communication operation, it is necessary to
configure the DIP address of each PACK first. The dialing code adopts BCD code format, the
definition of address 1(master) is ,address 2 is
To Next Page
Loading...